Pioneer makes several different sized Mini Split units with the 9000 BTU (3/4 Ton), 15 SEER Heat Pump Air Conditioner unit one of them.
The 9000 BTU unit is the smallest one with larger units going up-to 24,000 BTU and 240 volts.
The Pioneer mini split air conditioners are popular with Do-It-Yourself type individuals who are handy with small construction jobs and are looking to save money on a install.
It also has good feedback in many forums and other sources giving it many positive reviews.
There are other manufactures so be sure to read the reviews on other units to be sure it is a good fit for you.
Here is the Pioneer 9,000 Mini Split on Amazon
Pioneer Ductless Mini Split INVERTER Air Conditioner, Heat Pump, 9000 BTU (3/4 Ton), 15 SEER, Cooling, Heating, Dehumidification, Ventilation. Including 16 Foot Installation Kit. 110~120 VAC.
The following is a basic install of the Pioneer unit. Be sure to follow the instructions that come with any mini split package as designs can change.
The Pioneer unit is a full install kit that comes in three boxes, the outside condensing unit, inside evaporator that hangs on a wall, and a box with the line-set which runs between the two.
UnBoxing the packages everything is included except the electrical wiring to the pole which will require to be hooked to a breaker.
A 16 foot line-set is included that carries refrigerant to and from the inside and outside units.
The inside part called a evaporator is what will be hung from a wall.
The outside part is called the condenser and should have a hard surface to sit on. Most lay a small cement slab for it.
A bunch of other components and assessors are included such as drain hoses, filters, and a remote control.
A nice thing about the Pioneer is the wires that go from the inside unit to the outside unit are included which some mini split kits do not include.
The inside evaporator unit needs to be mounted on the wall. This should be thought out for the best spot. Keep in mind the 16 foot line-set needs to reach the outside unit.
The bracket needs to be level and a hole needs to be drilled in the correct spot so the copper line-set and wires can go out to the outside.
The instructions will show the correct measurements that the hole needs to be drilled at.
While the instructions have the measurements for the location to drill the hole it is a good idea to temporarily mount the inside unit making sure it lines up.
The bracket can be moved if needed as long as it is on solid studs but it is simply easier to be sure the hole is correct before any drilling is done.
The line-set than slides through the hole and the unit placed on its mounting bracket.
Wiring will also run outside through the hole to the outside unit.
Four wires ran outside with this unit. Be sure to follow the schematic that comes with your unit. The wires are clearly labeled and easy to connect up.
After the wiring and line-set are sticking outside the inside unit can be finished up by making sure it is pressed against the wall good.
Up next setting the outside condensing unit